메인으로

Do not use pipes and fittings with grooves or scratches.

It must not be cut at an angle.

The pipe cutting area and foreign substances on the inside/outside should be removed clearly.

Remove moisture: If moisture enters during applying the adhesive, there is a possibility of water leakage.

When applying adhsive, apply on the joint pipe first before applying on the pipe.

Apply evenly and equally on the inside.

Apply 3-4 times with a brush.

Be careful that the adhesive does not flow into the inside of the fittings.
Tip_When joining joint pipe with pipe diameter of 25mm~32mm, using 500g bond with small brush size is recommended.

Apply 3-4 times with a brush.

Apply thickly to the end of the pipe

As for appling adhesive, apply until you hear the "smacking" sound of CPVC material melting but in case adhesive has been applied on areas other than the joining part, wipe off.

Be careful that the adhesive does not flow into the inside of the pipe.

After applying, use sufficient amount of adhesive so that it can be rotated and assembled but ensure that the application amount is not excessive, causing overflow.

When inserting the pipe into the fitting, insert it while turning 1/4~1/2 of the pipe.
And hold for 5-10 seconds after insertion.

The bubble phenomenon of the adhesive on the joined part should be checked.

When combining female/male screws, wrap Teflon tape around the male screws sufficiently.

When connecting more than 40mm pipe, two people work jointly (to prevent non-insertion)

Open both ends of the pipe (at least more than 1 place) to discharge the residual gas within the pipe.

Be sure to observe the initial curing time and complete curing time for each standard.

If you work or pressurize before sufficient curing time has elapsed, the joint may be damaged.

* Check that the bond bead at the connection part is created 2mm or more